Why do the bulbs in my exterior fixture burn out so often?
This is usually caused by several factors:
1. Use of non-brand named bulbs.
2. Larger wattage bulbs, which cause excessive heat build-up shorting the life of the bulb.
3. Power Surges.

How do I reset my breaker when it has tripped off?
First, disconnect any additional devices that may have caused the breaker to overload and trip. Breakers are mechanical devices and must be turned all the way off before turning back on. Remember this is a mechanical device, so this may require several attempts. If this fails to reset the breaker, there may be a more serious problem.

What is the difference between a breaker panel and my old fuse panel?
Both devices, either breaker or fuse, are designed to trip (turn off) in the event of an electrical overload, i.e. 20Amps of electrical load on a 15Amp circuit would cause a trip. The only difference is that a breaker is mechanical and may be reset. Whereas, a fuse is one time only and must be replaced.
Please Note: Modern breakers are much more efficient and offer greater levels of protection.

When my air conditioner cycles on, I notice my lights blink. Is this normal?
Yes. This is a common occurrence when large motor/compressor loads start. These devices cause a minor momentary voltage drop, demonstrating itself as the blinking in your lights. This has no negative effect on the electrical equipment within your house.

What does it mean when my fluorescent lights are flickering or cycling on and off?
Flickering may indicate impending bulb failure, minor power fluctuation, and/or improperly installed bulbs. Cycling on and off is usually a clear indication of ballast and/or bulb failure. It is recommended when replacing a ballast to replace bulbs as well.